How to assemble and adjust seat lift chair table #13085N

Last Updated: Feb 25, 2015 10:07AM EST

How To Assemble a 13085N

 

  • Verify that all parts are present.





 

  • Make sure the trip rod in the column is fully inserted in the column.  If it is not shake the column until the trip rod is properly seated.





 

  • Slide the mast into the tabletop.


  • Line up the holes in the tabletop with the holes in the mast.





 

  • Insert one bolt in the hole furthest from the mast and hand tighten.





 

  • Install the remaining bolt into the hole closest to the mast and hand tighten.





 

  • Insert the trip lever with the curve part facing towards the bottom of the table.





 

  • Align the hole in the trip lever with the holes in the tabletop and mast and insert a bolt through the holes.





 

  • Install a nut on the bolt and tighten. Tighten the other two bolts.





 

  • The base must be placed under the seat lift chair before the mast is inserted on to the base to prevent the table from tipping over.







11.  Remove the black screw only.  DO NOT REMOVE THE SILVER SCREW THAT IS UNDER THE LABEL.




 

  • To move the table up, pull up under the table to the desired height (1).  To lower the table pull up on the release lever and push down (2).  The table can turn 360 degrees (3).



Did you find this article helpful?
149e5104a5a77a70d5d98654f32e7ebbe@drivemedical.desk-mail.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete