Prowler - Rhino 2 Flash Codes

Last Updated: Feb 25, 2015 01:33PM EST



When the Rhino 2 controller senses a fault the battery indicator lights will flash a number of
times, stop and then repeat the sequence.


 
Flash   
 
Meaning
 
Possible Reasons and Solutions
 
1 or 2 Low Voltage  
Check the battery cables and connections.
Charge the batteries.

 
3 High Voltage Fault
If driving downhill slow down and turn lights on, if so equipped.
Test the charger to ensure that it cuts off when batteries are fully charged.

 
4 Thermal Fault
The motor current has been at the maximum value too long.        
The motor may not be strong enough for the terrain (terrain to steep).
The wheels may be rubbing on the frame.
The motor may be faulty.
Test the motor.
Check the motor brushes.
The controller overheats.
Turn the unit off and let controller cool down.

 
5 Brake Fault
The brake is not engaged.
Engage the brake.
Check the brake wiring and connections.
Test the brake.
Replace the brake if defective.

 
6 Throttle or
Inhibit Fault

Throttle was engaged when unit was turned on.
Turn unit off  for 5 seconds and turn on without engaging the throttle.
Disconnect the charger if connected.

 
7 Throttle Fault
Check the throttle connections and wiring.     
Test the throttle.
Replace the throttle if  defective.

 
8 Motor Fault
Check the motor wiring and connections.
Test the motor.
Check the motor brushes.   
Replace the motor.

 
9 Controller Fault
 The controller has failed.
Check the controller connections and wiring.
Replace the controller.


                

 
Did you find this article helpful?
149e5104a5a77a70d5d98654f32e7ebbe@drivemedical.desk-mail.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete