Odyssey Flash Codes

Last Updated: Feb 25, 2015 01:30PM EST

When the Rhino controller senses a fault a number battery indicator LED lights will flash
  Possible Reasons and Solutions

Low Battery 
The battery voltage has dropped below a set value.

Low Battery

The battery voltage has dropped below a set value.


High Voltage


 The batteries are overcharged.
 If driving downhill slow down and turn lights on, if so equipped.
 Test the charge to ensure that it cuts off when batteries are fully charged.

4 Motor Fault
 The motor current has been at the maximum value too long.
 The motor may not be strong enough for the terrain (terrain to steep).
 The wheels may be rubbing on the frame.
 The motor may be faulty.
 Test the motor.
 Check the motor brushes.
 The controller overheats.
 Turn the scooter off and let controller cool down.

5 Brake Fault
 Brake is disengaged, engage the brake, turn the scooter off for 5 seconds.
 Check the brake connections and wiring.
 Test the brake.

6 Throttle Fault
 The throttle is misadjusted.
 Test and adjust the throttle.
 Replace the throttle if it cannot be adjusted.

7 Throttle Fault
 Throttle was engaged when unit was turned on.
 Turn unit off  for 5 seconds and turn on without engaging the throttle.

8 Motor Fault
 Check the motor connections and wiring.
 Check the motor brushes.
 Test the motor.

9   Controller Fault  
 Check the controller connections and wiring.
 Replace the controller.

Did you find this article helpful?
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found