How to install an electro magnetic brake on the Daytona

Last Updated: Feb 25, 2015 12:42PM EST

How To Install a Brake On a Daytona

  • Remove rear shroud.

  • Remove the rear axle bolt with a 13mm socket.

  • Remove the rear wheel.

  • Remove the zip tie.

  • Locate the electro magnetic brake connection to the wire harness.

  • Disconnect the electro magnetic brake.

  • Remove the three screws holding the electromagnetic brake to the motor.

  • Remove the electromagnetic brake.

  • Reverse these instructions to install the new electromagnetic brake.
Did you find this article helpful?
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found