Drive Medical

Return to Drive Medical

Technical Resource Center

How to assemble an Image EC

Last Updated: Feb 24, 2015 02:03PM EST

Image EC Assembly

 
  • Open top of the box using caution to avoid all metal staples.



 
  • Remove top packing material and seat assembly.



 
  • Have two people lift the scooter out of the box.



 
  • Remove all packing material and verify that all parts are present.



 
  • The batteries are shipped disconnected and must be reconnected. To access the batteries lift of the battery cover located in the rear of the base.



 
  • Locate the disconnected battery connector and wire harness connector.



 
  • Reconnect the battery connector to the connector in the wire harness.



 
  • Locate the seat plate protection cap on the bottom of the seat assembly.



 
  • Remove the protection cap and discard.



 
  • Install the seat assembly onto the Image EC base by sliding the seat plate into the seat tube.



 
  • Lift up on the seat swivel lever and turn the seat to properly set the seat on the seat post.



 
  • Install the left armrest into the left armrest receiver on the seat assembly.



 
  • Set the arm to the desired width and tighten the adjustment knob.



 
  • The height of the arm can be adjusted by loosening the arm height adjustment knob and moving the upper arm assembly to the desired position.



 
  • Repeat steps 12 through 14 for the right side armrest.



 
  • Insert the joystick arm into the joystick receiver located under the right armrest.  Set the joystick to the desired length and tighten the joystick adjustment knob.



 
  • Squeeze the headrest adjustment button on the right headrest receiver.  Insert the headrest into both headrest receivers.



 
  • Set the headrest to the desired height and release the headrest adjustment button.



 
  • Plug the AC end of the charger into a wall outlet.



 
  • The power light on the charger will be red.



 
  • Verify that the chair is turned off and remove the sticker covering the charger port on the joystick.



 
  • Plug the DC end of the charger into the charger port on the joystick.



 
  • The charge light on the charger will be yellow while charging.



 
  • When the batteries are fully charged the charge light will be green again. Disconnect the charger from the chair and the wall outlet.



 
  • The chair is now ready to use.  Verify that the free wheel levers are in the drive position.



 
  • Be aware with all the functions of the joystick before using the chair.


Contact Us

49e5104a5a77a70d5d98654f32e7ebbe@drivemedical.desk-mail.com
https://cdn.desk.com/
false
desk
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
false
Invalid characters found
/customer/en/portal/articles/autocomplete