How to assemble a 15500 E-Z assist pole

Last Updated: Feb 24, 2015 01:53PM EST

15500 Assembly

Identify the top end of the 15500 E-Z Assist Pole.

Identify the top plate.

Insert the top plate into the top of the 15500 E-Z Assist Pole.

Align the holes in the top bracket with the holes in the pole.

Locate the clevis pin, washer and hairpin.

Slide the clevis pin through the holes in the top plate and E-Z Assist Pole.

Slide the nylon washer over the end of the clevis pin and install the hairpin.

Slide the protective cover over the bottom end of the E-Z Assist Pole with the anti-rattler towards the top of the pole.

Slide the protective cover up high enough so that the jam nut is exposed. Adjust the length of the E-Z Assist Pole 2 inches less than the total ceiling height.

Place the jam nut cup into the base.

The top bracket must be positioned between two ceiling joists.

Insert the jam nut into the jam nut cup on the base plate.

Turn the jam nut until the E-Z Assist Pole is tight between the floor and the ceiling.

Slide the protective cover down over the jam nut.

The top bracket should be screwed into the ceiling joist for a secured installation.

Did you find this article helpful?
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found