How to replace a motor coupler

Last Updated: Jul 23, 2018 03:48PM EDT

How to replace a motor coupling

1. Using a drift punch tap out the roll pin that is holding the motor coupler on the motor shaft.  Use caution the coupler could spring off the motor shaft.

2. Slide the tension spring into the motor coupler.

3. Slide the new motor coupler over the motor shaft and align the slot in the coupler with the hole in the motor shaft.

4. Position the new roll pin over the hole in the shaft.

5. Tap the roll into the hole.

6. Continue tapping the roll pin until it is flush with the coupler.

Did you find this article helpful?
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found