How to install full rails on a long term care bed

Last Updated: Jul 23, 2018 03:46PM EDT

How To Install 15204 Full Rails On A Long Term Care Bed

1.  Verify that all parts are present.

2.  Raise the head section of the bed.

3. Lay one of the cross bars across the lower bed frame in front of the height actuating bar.

4. Align up the holes in the cross bar with the holes in the lower frame.  Insert one screw with one washer through each of the holes in the cross bar.

5. Install one nut on each of the two screws and tighten.

6. Raise the foot of the bed and slide the remaining cross bar across the lower frame just ahead of the foot section pivot point.   

7. Repeat steps 4 and 5.

8. Slide the side rail onto the two cross bars.

9. Install a washer and a nut on the end of both cross bars.  Do not over tighten.

10. Repeat steps 8 and 9 for the other side.  By swinging the side rail it will lock into place.

11. To lower the side rail squeeze the release lever and swing the side rail down.


Did you find this article helpful?
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found